Yamaha Digital Sound YSP-900 - Manual (Page 88)

84
En
TROUBLESHOOTING
■ Remote control
Problem Cause Remedy
See
page
The remote control does not work
and/or function properly. Wrong distance or angle. The remote control will function within a
maximum range of 6 m (20 ft) and no
more than 30 degrees off-axis from the
front panel. 22
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit. Reposition this unit. —
The batteries are weak. Replace all batteries. 22
You cannot operate external
components with this unit’s
remote control. The external component you want to
operate is not selected as the input
source. Press INPUT on the front panel or the
input selector buttons on the remote
control to select the external component
you want to operate. 37
The remote control code was not
correctly set. Set the remote control code correctly or
try another code for the same
manufacturer using the “LIST OF
REMOTE CONTROL CODES” at the
end of this manual. 77
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control. Use the remote control supplied with the
external component. —
The cursor buttons do not work
during SET MENU operation. The operation mode selector was
unwantedly set to TV/AV. Set the operation mode selector to YSP. —
You cannot use the my beam auto-
adjust function. Wrong distance or angle. The remote control will function within a
maximum range of 6 m (20 ft) and no
more than 30 degrees off-axis from the
front panel. 22
01EN_YSP-900_UAB_EN.book Page 84 Thursday, February 22, 2007 2:07 PM