Yamaha RX-V2700 - Manual (Page 130)

128
En
ADVANCED SETUP
W hen using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
■ Setting remote control AMP ID
1
Set the operation mode selector to AMP or
SOURCE.
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object and
then press
l / h repeatedly until “L;AMP”
appears in the display window on the remote
control.
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
3
Press ENTER.
The four-digit code set for the selected input area
appears in the display window on the remote control.
4
Press the numeric buttons to enter the
four-digit remote control code for the input
area you want to use.
Remote control AMP codes
Select one of the following codes to set the remote control
AMP code for the input area you want to use.
You need to set the corresponding remote control AMP ID
(see page 126).
5
Press ENTER to set the number.
“OK” appears in the display window if setting was
successful.
“NG” appears in the display window if the setting
was unsuccessful. In this case, start over from step 1.
6
Press LEARN again to exit from the setup
mode.
Setting remote control ID
Notes
TV
SOURCE
AMP
TV
SOURCE
AMP
or
LEARN
A/B/C/D/E
PRESET/CH
ENTER
A/B/C/D/E
PRESET/CH
ENTER
AMP library
code
(remote control
setting)
Function
Remote
control AMP
ID
2001
(initial setting)
To operate this unit using the
default code. ID1
(initial setting)
2002
To operate this unit using an
alternative code.
ID2
Note
4 3 2
0 9
5
1
7 6 8
STEREO SUR. DECODE SELECT EXTD SUR.
CLASSICAL LIVE/CLUB ENTERTAIN MOVIE
A/B/C/D/E
PRESET/CH
ENTER
LEARN