Porter-Cable PCG6500 - Manual (Page 21)

21 - ENG
GENErAL mAINTENANcE
Contact with a hot
engine or exhaust system can cause
serious burns or fires. Let the engine
and muffler cool before storing the
generator.
NOTE:
All generators contain
maintenance parts (e.g. oil, filters, etc.)
that are periodically replaced. These
used parts may contain substances that
are regulated and must be disposed of in
accordance with local and national laws
and regulations.
NOTE: Take note of the positions and
locations of parts during disassembly to
make reassembly easier.
NOTE: Any service operations not
included in this section should be
performed by a PORTER-CABLE factory
service center or a PORTER-CABLE
authorized service center.
The following procedures must be
followed when maintenance or service
is performed on the generator.
mAINTENANcE cHArT
procedure
Daily 50
hours or
weekly (w
hic
he
ve
r
comes
first)
100
hours
15
0 h
o
ur
s
or
monthly (w
hic
he
ve
r
comes
first)
500
Hours
Clean generator’s exterior X
Check oil level X
Change oil X*(1)
Clean air filter X(1)
Clean spark plugs X
Check fuel line, hose
clamps and fuel tank
X
Spark arrestor X
Oil leak inspection X
Sediment cup X
Clean fuel tank and filter X(2)
Check for unusual noise/vibration X
Check and adjust valve clearance
(.15 mm intake, .2 mm exhaust)
X (2)
Prepare unit for Storage
Prepare unit for storage if it is to remain
idle for more then 30 days
* The engine oil must be changed after the first 20 hours or operation. Thereafter
change oil every 150 hours of operation or monthly, whichever comes first.
(1) Perform more frequently in dusty or humid conditions
(2) Contact a Customer Care Center.