Sony ER-A420 - Manual (Page 83)

81
Job-Code-Based Programming
This section illustrates how to program items using job codes. Using job codes allows you to program a wide
variety of items in comparison with direct programming.
Start this programming by entering a corresponding job code as shown below.
All the items which can be programmed by the job-code-based programming are listed on this page and the
following, and those which can also be programmed by the direct programming are marked with the symbol
“
” that follows job codes.
Setting the date
Enter the month (one or two digits), day (two digits), and year (four digits: 2000 – 2099) in this sequence.
Setting the time
Set the time using the military time (24-hour) system. For example, when the time is set to 2:30 AM, enter 230;
and when it is set to 2:30 PM, enter 1430. The time is printed and displayed on the real time system.
Time
2611 . @
1430 Ç
Print Key operation
Example
2611
. @ Ç
Time (max. four digits)
Procedure
Direct 2611 PGM 2
Date
2610 . @
08262004 Ç
Print Key operation
Example
2610
. @ Ç
Date (seven or eight digits)
Procedure
Direct 2610 PGM 2
Setting the date and time 1
Direct
2110
. @
ER-A410/A420(SEC)-3 03.12.22 0:18 PM Page 81