Repeater call sign programming – Icom IC-U82 User Manual
Page 64
52
11
DIGITAL MODE OPERATION
■
Repeater call sign programming
Repeater call sign must be programmed for repeater opera-
tion in both digital voice and low speed data communications.
q Push
[A•
FUNC
] and [0•
OPT
]
to enter
OPTION SET MODE
, then
push
[
Y
Y
]
or
[
Z
Z
]
several times to select the call sign items.
• “R1C” or “R2C” appears for repeater call sign.
w Push and hold
[0•
OPT
]
for 1 sec. then rotate
[VOL]
to se-
lect the desired call sign channel.
e Push
[
Y
Y
]
to select call sign programming mode.
• The 1st digit blinks and channel indication stops blinking.
r Rotate
[VOL]
to set the desired character or code.
• Push
[
Z
Z
]
or
[
Y
Y
]
to move the cursor to left or right, respectively.
t Push
[
Y
Y
]
to select 2nd digit, then rotate
[VOL]
to set the
desired character or code.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming repeater call sign.
y Push
[0•
OPT
]
to save the call sign.
u Rotate
[VOL]
to select an another channel from “C1” to
“C6.”
i Repeat steps w to u to program other repeater call sign
channels.
✔
For your information:
Station and/or repeater call sign can be programmed from
Received call record when a call is received.
See page 46 for details.
✔
For your information:
Repeater call sign can be programmed for gateway connec-
tion capabilities at step r for connecting to the another Area
or Zone.
• “G” appears or disappears as the 8th digit when pushing
[8•
SET
]
.
While using the repeater 2 (other Area or Zone) system, the
repeater 2 setting must be selected ON in
OPTION SET MODE
.
• “R2C” (Repeater 2 call sign) can be programmed or used when
“RP2” (Repeater 2 setting) is set to ON (default).