Installing and removing the intel, Remote management module and the intel, Rmm nic – Intel SR1500AL User Manual

Page 78: Installing the intel, Rmm and intel

Intel

Server System SR1500AL User’s Guide

9. Install the processor air duct. For instructions, see

“Installing the Processor Air

Duct”

10. Install the server system cover. For instructions, see

“Installing the System Cover”

11. Plug all peripheral devices and the AC power cable(s) into the server.

Installing and Removing the Intel

Remote

Management Module and the Intel

RMM NIC

Installing the Intel

RMM and Intel

RMM NIC

1. Observe the safety and ESD precautions at the beginning of this book. See

“Safety

Information”

2. Power down the server and unplug all peripheral devices and the AC power

cable(s).

3. Remove the server system cover. For instructions, see

“Removing the System

Cover”

4. Remove the PCI riser assembly. For instructions, see

“Removing the PCI Riser

Assembly”

5. Squeeze the sides of the Intel

RMM NIC module cover to disengage it from the

server system back panel and remove it. See letter “A” in the figure below.

6. Attach the standoffs to the server board (see letter “B” in the figure below) and

attach the Intel

RMM NIC module to the server board (see letter “C” in the figure

below).

7. Insert the standoff into the hole labeled TH4 on the Intel

RMM board (see letter

“D” in the figure below). The standoff installs on the bottom side of the Intel

RMM board.

8. Attach the Intel

RMM board to the server board connector and snap the standoff

into the matching hole on the server board.

Figure 46. Installing the Intel

RMM and the Intel

RMM NIC Module to the

Server System

AF000747