Installing and removing the pci riser assembly, Removing the pci riser assembly – Intel SR1500AL User Manual
Page 69
Intel
®
Server System SR1500AL User’s Guide
47
Installing and Removing the PCI Riser Assembly
Removing the PCI Riser Assembly
To remove the PCI riser assembly, use the following instructions.
1. Observe the safety and ESD precautions at the beginning of this book. See
“Safety
Information”
.
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
“Removing the System
Cover”
.
4. Remove the processor air duct by lifting straight up.
5. Disconnect any cables attached to any add-in cards.
6. Grasp both riser latches with thumb and forefinger (see letter “A”), and pull up to
release riser assembly.
7. Lift riser assembly straight up (see letter “B”).
Figure 38. Removing PCI Riser Assembly from the Server System
AF000358
A
B
A