ICP DAS USA I-7540D - Manual (Page 58)

Port 10000 Command Format: 99
99 :
Specific command for getting or setting the status of the
7540D
Table 4-2: Command list table (port 10000)
Command Description
S Read the status value of i-7540D
C Clear CAN error flag and FIFO
RA Reboot the i-7540D module.
#P01 Read the RS-232 configuration
#P02 Read the RS-485 configuration
#P1 Read the CAN configuration
#P1B Read the BTR0 and BTR1 configuration
$P0105BBDSP Change the RS-232 configuration
$P0205BBDSP Change the RS-485 configuration
$P114PBCC…MM…ET Change the CAN configuration
$P1B04TTRR Change the BTR0 and BTR1 configuration
#PWID Read Web ID configuration
#PWPW Read Web Password configuration
$PWIDLLxxxxx… Change Web ID configuration
$PWPWLLxxxxx… Change Web Password configuration
#PPC Read CAN Pair Connection configuration
#PPIP Read CAN Pair Destination IP
$PPCLLABC Change CAN Pair Connection configuration
$PPIPxxx… Change CAN Pair Destination IP
Note:
1. More detailed information related to of the each command will be described in
the following sub sections.
2. The #P1B and $P1B04TTRR commands just can be used on the firmware
version v1.04 or later.
3. The #PWID, #PWPW, $PWIDLLxxxxx…, $PWPWLLxxxxx… commands just
can be used on the firmware version v1.05 or later.
4. The #PPC, #PPIP, $PPCLLABC, $PPIPxxx… commands just can be used on
the firmware version v1.06 or later.
i-7540D CAN-Ethernet Gateway User’s Manual (Version 1.4, April/2008) 58