Integra RDV-1.1 - Manual (Page 15)

15
Before Use
The Worldwide model has a voltage selector for compat-
ibility with power systems around the world. Before you
plug in this model, make sure that the voltage selector is
set to the correct voltage for your area. If it isn’t, use a
small screwdriver to set it as appropriate. For example, if
the voltage in your area is 120 volts, set the selector to
“120V.” If it’s between 220 and 230 volts, set it to “220-
230V.”
Notes:
• The supplied batteries should last for about six
months, although this will vary with usage.
• If the remote controller doesn’t work reliably, try
replacing both batteries.
• Don’t mix new and old batteries, or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
• Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
To use the remote controller, point it at the RDV-1.1’s
remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the
RDV-1.1 is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing the RDV-1.1.
• If another remote controller of the same type is used in
the same room, or the RDV-1.1 is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the
RDV-1.1 is installed in a rack behind colored glass
doors. Keep this in mind when installing the RDV-1.1.
• The remote controller will not work if there’s an obsta-
cle between it and the RDV-1.1’s remote control sen-
sor.
Setting the Voltage Selector
(Worldwide model only)
Installing the Remote’s Batteries
1 To open the battery compartment, press
the small hollow and slide off the cover.
2 Insert the three supplied batteries (AA/R6)
in accordance with the polarity markings
inside the battery compartment.
3 Put the cover onto the remote controller
and slide it shut.
VOLTAGE SELECTOR
220-230V 120V
COAXIAL OPTICAL OPTICAL COAXIAL
DIGITAL 1 DIGITAL 2
DIGITAL 2 ( BALANCED) AES/EBU
AUDIO OUT
MODEL NO. RDV- 1.1 DVD PLAYER
AC INLET
D. MIX FRONT SURR 1 CENTER SURR 2
L
R
L
R
IN
SUB
WOOFER
1
2
Y PB PR
OUT OUT
IN
REMOTE CONTROL
VIDEO OUT COMPONENT
VIDEO S VIDEO VIDEO
S VIDEO
Y
PB
PR
Y
PB
PR
IN
1 + 2 1
RS 232 HDMI VIDEO IN IR
S400 ( AUDIO)
AUDIO OUT
HD VIDEO OUT COMPONENT
12V
TRIGGER
SURR MODE (AUDIO OUT)
220-230V 120V
VOLTAGE SELECTOR
Using the Remote Controller
30˚
30˚
RDV-1.1
Appro
x.
16 ft.
(5 m)
Remote control sensor