Furuno FM-4000 - Manual (Page 43)

Page 43 FM-4000
7. When an Individual call acknowledgment is re-
ceived, the channel selected at step 5 is auto-
matically selected and a ringing tone sounds.
8. Press [CLR] key to listen to the channel to make
sure it is not busy, then key the microphone to
call the other vessel.
Manual Calling
You may enter an MMSI number manually to contact a vessel which is not
stored in the Individual Directory.
1. Press the [CALL(MENU)] key to show the “DSC DSC DSC DSC DSC
Call Menu Call Menu Call Menu Call Menu Call Menu .”
2. Turn the CHANNEL selector knob to select “In- In- In- In- In-
dividual dividual dividual dividual dividual .” (To cancel, press the [CLR] key.)
3. Press the [ENT] key. The transceiver beeps
then the “Individual directory” appears.
4. Turn the CHANNEL selector knob to select
“ Manual Manual Manual Manual Manual ,” then press the [ENT] key.
5. Enter the MMSI number (nine digits) which you want
to contact, then press the [ENT] key.
6. If you enter the wrong number in the MMSI number,
press the [H/L] key until the wrong number is se-
lected, then enter the correct number.
7. When you are finished entering the MMSI number,
press and hold the [ENT] key.
8. Turn the CHANNEL selector knob to select
“ Manual Manual Manual Manual Manual ,” then press the [ENT] key.
9. Turn the CHANNEL selector knob to select the
operating channel you want to communicate on, then
press the [ENT] key.
10. Press the [ENT] key again to transmit the indi-
vidual DSC signal.
11. When an Individual call acknowledgment is re-
ceived, the channel selected at step 5 is auto-
matically selected and a ringing tone sounds.
12. Press the [CLR] key to listen to the channel to
make sure it is not busy, then key the micro-
phone to call the other vessel.