Furuno FM-4000 - Manual (Page 28)

FM-4000 Page 28
the highest programmed channel number and will
stop on a channel when a transmission is received.
6. The channel number will blink during reception.
7. To stop scanning, press the [CLR], [16/9], or [WX]
key.
10.13.3 Priority Scanning (P-SCAN)
In the default setting, Channel 16 is set as the priority channel. You may change
the priority channel to the desired channel from CH16 on the Radio Setup
menu. See section “10.13.1 Selecting the Scan Type,” and “12.6 PRIORITY
CHANNEL SET.”
1. Adjust the SQL knob until background noise disappears.
2. Use the CHANNEL selector knob to select the channel to scan. Press the
[F] key followed by the [2(MEM)] key. “MEM” ap-
pears on the display, which indicates that the chan-
nel is programmed into the transceiver’s memory.
3. Repeat step 2 to select all the channels to scan.
4. To DELETE a channel from the transceiver’s memory, select the channel
then press the [F] key followed by the [2(MEM)] key. “MEM” is removed
from the display.
5. To start priority scanning, press the [F] key followed by the [3(SCAN)] key.
“ P-SCAN P-SCAN P-SCAN P-SCAN P-SCAN ” appears on the LCD. Scanning will pro-
ceed between the memorized channels and the pri-
ority channel. The priority channel will be scanned
after each programmed channel.
6. To stop scanning, press the [CLR], [16/9], or [WX] key.
You may change the scan resume time in the Radio Setup menu. See section
“12.8 SCAN RESUME TIME.”