Furuno FS-1570 - Manual (Page 122)

7 DSC/WATCH RECEIVER SETUP
7-4
Default: ABLE
** Auto ack setup **
COMPLY TYPE : ABLE
UNABLE REASON :
NO REASON GIVEN
POSITION CALL : OFF
POLLING CALL : ON
UNABLE
ABLE
Choose ABLE or UNABLE as automatic
acknowledgement reply to Individual,
Position and Polling calls.
Note: Automatic acknowledge is
automatically disabled when RX call
contains error, as required by law.
Further, automatic acknowledge is
disabled in case of OFF HOOK.
Automatic acknowledge of Position
or Polling request is not available
Default: NO REASON
NO REASON
BUSY
EQUIP DISABLED
MODE NOT USABLE
CH NOT USABLE
Sets reason for UNABLE.
Note: This menu is the same as manual
acknowledgement. EQUIPMENT
DISABLED is shown in calls when
Default: ON
Overrides/follows AUTO ACK
setting in case of position.
OFF: Disables automatic
acknowledgement of
position request.
ON: Enables automatic
acknowledgement of
position request.
[ENTER]
knob
[ENTER] knob
[ENTER] knob
OFF
ON
Default: ON
Overrides/follows AUTO ACK
setting in case of polling.
OFF: Disables automatic
acknowledgement of
polling request.
ON: Enables automatic
acknowledgement of
polling request.
OFF
ON
Rotate
[ENTER]
knob to
choose.
Rotate
[ENTER]
knob to
choose.
Rotate [ENTER]
knob to choose
Rotate [ENTER]
knob to choose.
[ENTER] knob
7.4 Erase File Menu
The Erase file menu allows you to erase the entire contents of the received ordinary log,
received distress log, transmitted log and send message log.
1. Press the [#/SETUP] key.
2. Choose ERASE FILE and then push the [ENTER] knob to display the Erase file menu.
3. Choose the item to erase and then push the [ENTER] knob.
4. Choose YES and then push the [ENTER] knob.