Code 128 message length, Code 128 function code transmit, Telepen – Hand Held Products HANDHELD 3800G User Manual
Page 76: Code 128 code page, Default all telepen settings
7 - 16
Code 128 Message Length
Scan the bar codes below to change the message length. Refer to
on page 7-2 for additional information. Minimum and Maximum
lengths = 0-80. Minimum Default = 0, Maximum Default = 80.
Code 128 Code Page
Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the bar
code being scanned was created using a code page that is different from the one
the host program is expecting. If this is the case, scan the bar code below, select
the code page with which the bar codes were created from the chart,
on page A-4, and scan the value and the SAVE
inside the back cover of this manual. The
data characters should then appear properly.
Code 128 Function Code Transmit
By default, Code 128 function codes are not transmitted with Code 128 bar code
data. However, if you wish to transmit Code 128 function codes with the bar code
data, scan the Function Codes On bar code, below.
Telepen
Minimum Message Length
Maximum Message Length
Code 128 Code Page
* Function Codes Off
Function Codes On