Hearth and Home Technologies Cinch Pipe & Termination Cap System - Manual (Page 12)

Hearth & Home Technologies Inc. • Cinch Pipe & Term Caps • 4033-900 Rev K • 05/05 12
H. Assemble and Install Storm Collar
Connect both halves of the storm collar with two screws (see
Figure 2.21).
Wrap the storm collar around the exposed pipe section and
align brackets. Insert a bolt (provided) through the brackets
and tighten nut to complete the storm collar assembly (see
Figure 2.22). Make sure the collar is tight against the pipe
section.
Slide the assembled storm collar down the pipe section until
it rests on the roof fl ashing (see Figure 2.19).
Caulk around the top of the storm collar.
Sharp Edges!
• Wear protective gloves and safety
glasses during installation.
CAUTION
Figure 2.22 Assembling the Storm Collar Around the
Pipe
Figure 2.21 Assembling the Storm Collar