Multi-processor lockstep population order, Installing a dimm – HP BL460C G7 User Manual
Page 34

Hardware options installation 34
Multi-processor Lockstep population order
For Lockstep memory mode configurations with multiple processors, populate the DIMM slots for each
processor in the following order:
•
RDIMM
o
First: A and B
o
Next: D and E
o
Do not populate slots C or F.
•
UDIMM
o
First: A and B
o
Last: D and E
o
Do not populate slots C or F.
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support.
Installing a DIMM
CAUTION:
To avoid damage to the hard drives, memory, and other system components, the air
baffle, drive blanks, and access panel must be installed when the server is powered up.
1.
Power down the server ("
" on page
2.
Remove the server blade (on page
3.
Remove the access panel (on page
4.
Remove all DIMM baffles ("
" on page
5.
Open the DIMM slot latches.
6.
Install the DIMM.
7.
Install all DIMM baffles.
8.
Install the access panel (on page
If you are installing DIMMs in a mirrored or lock-step configuration, configure this mode in RBSU ("
" on page