Huffy VP8100 - Manual (Page 12)

12
P/N 211636C 07/03
3. Mark pole sections with tape (not supplied) as shown.
6
5
4
4.
WOOD SCRAP
(NOT SUPPLIED)
5
4
IMPORTANT! Center alignment slot of middle pole
section (5) in a lower hole of top pole section (4) as
shown. While maintaining alignment, bounce middle pole
section (5) into top section (4) using a wood scrap, as
shown, until the top pole no longer moves toward the taped
reference mark on the middle pole. Upright assembly.
NOTE: Pole sections should have a 3-1/2” (9 cm) overlap
minimum.
Tape (Not Supplied)