Hunter Fan 47350A - Manual (Page 8)

14
14 PROGRAMMING
Setting Time and Day
■ The LCD will show this information when batteries
are first installed, or after the Reset button is
pressed. The temperature will update after a few
seconds.
■ During time and day setting mode, the temperature
and program displays will go blank.
■ Example: Set the Thermostat to the current time of
2:16 pm on Saturday. Refer to the Steps below.
STEP 1: ■ Press to enter time and day setting mode. The cur-
rent hour and the AM / PM indicator will be flashing.
■ Press to change the Hour up or down to the
current hour.
Note the AM / PM indicator, as the display will
change at 12 AM and 12 PM.
STEP 2: ■ Press again to change from hour setting to minute
setting. The current minute will be flashing.
■ Press to change the Minute up or down to the
current minute.
TEMP
AM
M
4
AM
M day/time
day/time
PM
M
41659_model47350A_web.pmd
15
STEP 3: ■ Press again to change from minute setting to day
setting. The current day will be flashing.
■ Press to change the Day up or down to the
current day.
STEP 4: ■ Press again to change back to the
normal display.
NOTE: You may press hold
/return
at any time during Day and Time setting to return to the
normal display.
DAYLIGHT SAVING TIME
■ Press and hold.
■ Press to enter Daylight Saving Time.
PM
M
TEMP
PM
SA
2
day/time
day/time
hold
/return
or
TEMP
2
AM
SA SET TEMP
day/time
or
(continued)