Hoover S3670 - Manual (Page 6)

2-11
2-12
Select the proper tool
H. Crevice tool may be used in tight spac-
es, corners, and along edges in such places
as dresser drawers, upholstered furniture,
stairs and baseboards.
I. Combination tool may be used for
carved furniture, table tops, books, lamps,
lighting fixtures, venetian blinds, baseboards,
shutters and registers. May also be used for
upholstered furniture, draperies, tapestries,
mattresses and clothing.
J. Hard floor tool may be used for walls
and very irregular hard surface floors such as
brick and slate.
K. Powered hand tool may be used for
upholstered furniture, carpeted stairs, and
hard to reach places.
Variable speed control
The variable speed control (F) is located on the
canister.
Push the (—) button to reduce energy consump-
tion and to clean lightly soiled areas or delicate
fabrics. Push the (+) button for maximum clean-
ing power in heavily soiled areas. If the power
nozzle is difficult to push, push the (—) button to
reduce the power.
Edge cleaning
Special edge groomers are provided on both
sides of the nozzle to remove dirt in carpet near
baseboards and furniture. Guide side of noz-
zle parallel to edge of carpet or furniture as
shown.
6
2-8
F
2-10
Cleaning tools
The cleaning tools are conveniently stored in
the cleaner underneath the tool lid (M). Push
the tool lid release latch to open (N).
The cleaning tools have many uses. Select
the tool best suited for the cleaning task from
the following descriptions.
H I K
J
2-9
M
Slide combination tool apart to reveal second
tool.
Attaching tools
Tools may be attached directly to the hand
grip or to the wand. Firmly push tool into the
hand grip or wand. Twist tool slightly to tight-
en or loosen connection.
2-7
N