Hoover S3670 - Manual (Page 12)

Service
To obtain approved HOOVER service and gen-
uine HOOVER parts, locate the nearest
Hoover Factory Service Center or
Authorized Hoover Warranty Service
Dealer (Depot) by:
• checking the Yellow Pages
under “Vacuum Cleaners -
Household” OR -
• calling 1-800-944-9200 for an
automated referral of authorized
service outlet locations (U.S. only)
OR-
• checking the Service section of Hoover,
Inc., online at www.hoover.com
Please do not send your cleaner to The
Hoover Company in Glenwillow for service, this
will only result in delay.
If further assistance is needed, contact
Hoover, Inc., Consumer Response Center,
Glenwillow, Ohio 44139, Phone:
1-800-263-6376 Mon-Fri 8AM-7PM EST.
In Canada, contact Hoover Canada,
Etobicoke, Ontario M8W 3R9, Phone:
1-800-263-6376 Mon-Fri 8AM-7PM EST.
Always identify your cleaner by the complete
model number when requesting information or
ordering parts. (The model number appears
on the bottom of the cleaner.)
Lubrication
The motor is equipped with two bearings
that contain sufficient lubrication for the life
of the motor. The addition of lubricant could
cause damage. Therefore, do not add
lubricant to either motor bearing.
The agitator brush roll is equipped with two
ball bearings that should be lubricated peri-
odically by a Hoover Factory Service Center
or an authorized Hoover Warranty Service
Dealer (Depot).
Powered hand tool
Belt replacement
Inspecting the belt
The powered hand tool belt is designed to
last a long time and is not normally replaced.
However, if the belt is cracked, gouged or
broken, it should be replaced.
12
3-27
3-28
The belt can be seen through the top of the
nozzle or by removing the bottom plate and
belt guard (Figs. 3-21 and 3-22).
2. Grasp turbine (E) and pull firmly to remove.
3. Remove belt from turbine pulley (F).
Replace with new belt.
Replacing belt
When replacing belt, ask for HOOVER part
no. 38528037.
1. Remove bottom plate, belt guard and
brush roll as described in Figs. 3-21 through
3-23.
4. With flat sides of turbine retainers (G)
pointing down, slide retainers into grooves
(H) on both sides of tool housing and snap
into place.
5. Replace brush roll, belt guard, and bottom
plate as described in Figs. 3-23 through 3-26.
F
E
G
H
3-29