Harbor Freight Tools CENTRAL MACHINERY 93380 - Manual (Page 5)

SKU 93380 For technical questions, please call 1-800-444-3353. Page 5
22. Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool may become hazardous
when used on another tool.
SERVICE
23. Tool service must be performed only by qualified repair personnel. Service
or maintenance performed by unqualified personnel could result in a risk of injury.
24. When servicing a tool, use only identical replacement parts. Follow
instructions in the
“Inspection, Maintenance, And Cleaning” section of this
manual. Use of unauthorized parts or failure to follow maintenance instructions
may create a risk of electric shock or injury.
SPECIFIC SAFETY RULES
1. Ground this product. This Table Saw requires the attachment and use of a UL
approved, 220 volt, grounded, 3-prong, electrical Power Cord Plug (not included).
Only a qualified electrician should install the Power Cord Plug. Never remove the
grounding prong or modify the Power Cord Plug in any way. Do not use adapter
plugs with this product. To comply with the National Electric Code, and to provide
additional protection from the risk of electrical shock, this product should only be
connected to a 220 volt, 3-hole outlet that is protected by a Ground Fault Circuit
Interrupter (GFCI). (See Figure A, page 10.)
2. Maintain labels and nameplates on the Table Saw. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement.
3. Avoid unintentional starting. Make sure you are prepared to begin work
before turning on the Table Saw.
4. Do not force the Table Saw. This tool will do the work better and safer at
the speed and capacity for which it was designed. Do not force the Saw Blade
into the workpiece being cut.
5. WARNING! Keep hands and fingers away from cutting area and Saw
Blade. Use a “push stick” (not included) if necessary.
6. Never leave the Table Saw unattended when it is plugged into an
electrical outlet. Turn off the tool, and unplug it from its electrical outlet before
leaving.