Harbor Freight Tools CENTRAL MACHINERY 93380 - Manual (Page 22)

SKU 93380 For technical questions, please call 1-800-444-3353. Page 22
V-BELTS (40)
SET SCREW (39)
MOTOR PULLEY
(38)
MOTOR (34)
SHAFT
FIGURE T
10. Recheck the Blade Guard Assembly alignment to the Saw Blade and the Main
Table (115) top. If the Blade Guard Assembly is properly aligned reattach the
Main Table, Left Wing (113), and Right Wing (114), making sure there is adequate
Saw Blade clearance through all Saw Blade adjustments.
11. Adjust the Saw Blade to 45 degrees. Raise and lower the Saw Blade through the
full range. Readjust the Saw Blade to 90 degrees, then raise and lower the Saw
Blade through the full range. There should be no contact between the Saw
Blade, the Main Table, the Table Insert, or any other part of the Table Saw. If
there is contact, have a qualified service technician make the necessary
adjustments before using the Table Saw.
To Adjust The 45 Degree And 90 Degree Positive Stops:
1. The Stops have been adjusted at the factory. After a period of use, or after moving
the Table Saw from one location to another, the Stops may no longer be set prop-
erly. (See Figure U, next page.)
2. Set the Saw Blade angle at zero as shown on the Angle Scale (9) on the front of
the Table Saw, and raise the Saw Blade to the maximum height using the Hand
Wheel (61). (See Assy. Diagram.)
3. Set the Saw Blade at 90 degrees to the Main Table (115) by turning the Hand
Wheel (28) clockwise as far as it will go. (See Assy. Diagram.)
4. Place a square on the Main Table (115) and check to see that the Saw Blade is at
a 90 degrees angle to the Main Table. Make sure the square is touching the
side of the Saw Blade. (See Figure U.)