Harbor Freight Tools CENTRAL MACHINERY 93380 - Manual (Page 21)

SKU 93380 For technical questions, please call 1-800-444-3353. Page 21
4. If the Splitter (315) is to the right of the Saw Blade, add washers between the
Splitter and the front mounting bracket. Then, adjust the rear Splitter support.
(See Figure R.)
FIGURE R
5. Recheck the Splitter (315) alignment to the Saw Blade and to the Main Table
(115) top. Adjust as necessary, and tighten all loose bolts before use.
6. NOTE: If the Splitter (315) is positioned to the left of the Saw Blade, alignment
cannot be achieved by adding washers. Therefore, remove the Main Table (115),
Left Wing (113), and Right Wing (114) and set them aside.
7. Loosen the Adjustment Bolt shown in the illustration below, and slowly slide the
Arbor Bracket toward the end of the Shaft. Only move the Arbor Bracket a
distance equal to the amount of misalignment between the Saw Blade and the
Splitter, or slightly a little more (you can always adjust the Splitter back to the left
with washers). (See Figure S.)
8. Tighten the Adjustment Bolt securely. (See Figure S.)
9. Moving the Arbor Bracket moves the V-Belts (40) and Pulleys (99) out of
alignment, so adjustment of the Motor Pulley (38) is required. To do so, loosen the
Set Screw (39) in the middle groove of the Motor Pulley (38) and slowly slide the
Pulley toward the end of the Motor (34) Shaft. Once the V-Belts are back in
alignment, tighten the Set Screw securely. (See Figure T.)
FIGURE S