Harbor Freight Tools CENTRAL MACHINERY 93380 - Manual (Page 18)

SKU 93380 For technical questions, please call 1-800-444-3353. Page 18
STANDARD
TABLE INSERT
(116A)
SET SCREW
(117A)
SET SCREW
(117B)
SET SCREW
(117A)
SET SCREW
(117B)
FIGURE L
To Install The Blade Guard Assembly:
1. Thread the blade guard Shaft (74) into the hole in the Back Trunnion (75) located
at the rear of the Table Saw, and firmly tighten the Shaft. (See Figure M.)
2. Place the Lower Guard Bracket (120) over the Shaft (74), and tighten the two
Set Screws (121). (See Figure M.)
3. Place the L-Bracket (122) onto the Lower Guard Bracket (120). Secure the L-Bracket
to the Lower Guard Bracket, using two Bolts (129), two Elastic Washers (128), and
two Flat Washers (127). Do not tighten firmly at this time. (See Figure M.)
SHAFT (74)
LOWER
GUARD BRACKET
(120)
SET
SCREW
(121)
L-BRACKET (122)
BOLT (129)
ELASTIC WASHER (128)
FLAT WASHER (127)
FIGURE M
SPLITTER (315)
BOLT (123)
FLAT WASHER (124)
ELASTIC WASHER (125)
NUT (126)