Harbor Freight Tools CENTRAL MACHINERY 93380 - Manual (Page 24)

SKU 93380 For technical questions, please call 1-800-444-3353. Page 24
side of the Saw Blade to the right T-Slot edge in the Main Table (115) using a
combination square. Make sure to measure between the teeth, not on the tooth.
(See Figure V.)
4. Rotate the Saw Blade toward the front so that the marked tooth is just above the
Table Insert (116A, 116B). Measure the distance from the side of the Saw Blade
to the right T-Slot edge. The two measurements should be the same.
(See Figure V.)
FIGURE V
5. If the measurements are not the same, loosen the four Bolts (16) that hold the
Main Table (115) to the Cabinet (1). Adjust the Main Table until the two
measurements are the same. Then, retighten the four Bolts. (See Figure W.)
FIGURE W
OPERATING INSTRUCTIONS
Basic Operation For Using The Rip Fence Assembly:
1. WARNING! Always wear safety impact eye goggles and heavy work gloves
when using the Table Saw.
TABLE MOUNTING HOLES