HP NetVectra N20 - Manual (Page 11)

English 5
1 Setting Up and Using Your PC
Connecting the Power Cables
Connecting the Power Cables
WARNING
For your safety always connect the equipment to a grounded wall outlet.
Always use a power cord with a properly grounded plug, such as one provided
with this equipment, or one in compliance with your national safety standards.
This equipment is disconnected from the power by removing the power cord
from the power outlet. This means that the equipment must be located to a
power outlet that is easily accessible.
1 Remove the warning label covering the PC’s connector, and ensure that the
voltage is correct for your country (The voltage is set during manufacture
and should already be correct).
CAUTION
Starting your PC on the wrong voltage setting may cause it permanent damage.
NOTE
If you have a CD-ROM drive, carefully remove the cardboard insert from the
drive before starting your PC.
Voltage Selection
Switch
1
2
3
4
drac-usr.bk : drac.fb4 Page 5 Friday, April 30, 1999 3:48 PM