HP Q5693A - Manual (Page 16)

8 2 Configuring the MBM for your work environment ENWW
If a print or copy job is sent to a bin that is full, the printer or MFP stops printing (even if the other
bins are not full). For the printer or MFP to continue printing, you must remove the media from
the full bin.
Setting an operation mode
After you set the operation mode at the printer or MFP control panel, you need to configure the
printer driver so that it matches the operation mode that you set at the control panel.
HP LaserJet 9040/9050 series printers
1 Use or to scroll to CONFIGURE DEVICE , and then press .
2 Use or to scroll to MBM-8 CONFIG , and then press .
3 Use or to scroll to OPERATION MODE , and then press .
4 Use or to scroll to the operation mode that you want, and then press . The printer
restarts.
5 Continue to “Setting the operation mode in the printer driver to match the control-panel
setting” on page 8 .
HP LaserJet 9040mfp/9050mfp/9500mfp
1 Press the M ENU button.
2 Scroll to and touch CONFIGURE DEVICE .
3 Scroll to and touch MBM-8 CONFIG .
4 Scroll to and touch OPERATION MODE .
5 Scroll to the operation mode that you want, and then touch OK . An asterisk (*) appears next
to your selection. The MFP restarts.
6 Continue to “Setting the operation mode in the printer driver to match the control-panel
setting” on page 8 .
Setting the operation mode in the printer driver to match the
control-panel setting
The operation-mode setting in the printer driver needs to match the operation mode that was
selected at the control panel to ensure that print or copy jobs are delivered to the expected
destination bin.
Note The illustrations in this section show the text in English. Depending on the operating system that
you are using and what settings you have set, your screens might or might not look like these
illustrations.
Microsoft® Windows® 2000 and Windows XP
1 Click the Start button, point to Settings, and then click Printers (Windows 2000) or Printers
and Faxes (Windows XP).
2 Right-click the HP product icon, and then click Properties or Printing Preferences.
3 Click the Device Settings tab.
4 Perform one of the following actions: