Hoshizaki KML "F" SERIES User Manual
Page 108
108
3. SANITIZING PROCEDURE
- Following Cleaning Procedure
1) Dilute a 5.25% Sodium Hypochlorite solution (chlorine bleach) with water (Add
1.0 fl. oz. to 2 gal. of water).
2) Remove the Insulation Panel.
3) Pour the sanitizing solution into the Water Tank.
4) Move the Service Switch to the “WASH” position.
5) Replace the Insulation Panel and the Front Panel in their correct position.
6) Turn on the power supply and start the sanitizing process.
7) Turn off the power supply after 15 minutes.
8) Remove the Front Panel.
9) Move the Service Switch to the “DRAIN” position.
10) Replace the Front Panel and turn on the power supply for 2 minutes.
11) Turn off the power supply.
12) Remove the Front Panel.
13) Repeat the above steps 18) through 31) in “CLEANING PROCEDURE” two times
to rinse thoroughly.
14) Move the Control Switch to the “ICE” position.
27) Remove the Front Panel.
28) Move the Service Switch to the “DRAIN” position.
29) Replace the Front Panel and turn on the power supply for 2 minutes.
30) Turn off the power supply.
31) Remove the Front Panel.
32) Repeat the above steps 18) through 31) three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to step 14) in “SANITIZING PROCEDURE.”