HP 3COM ETHERLINK III 3C900-B - Manual (Page 13)

11
Connecting to a Novell NetWare 4.11 Server
Microsoft Windows NT 4.0 Workstation
7 Connecting to a Novell NetWare 4.11 Server
Microsoft Windows NT
4.0 Workstation Requirements
Procedure
1 With the HP Vectra turned off, install the network adapter into a PCI slot.
2 Connect the network cable to the newly installed network adapter.
3 Power on the machine and boot to Windows NT.
4 Log into Windows NT with administrator privileges.
5 The following steps are based on a first-time installation of Networking on
the system. Adding a NIC to a previously installed Networking has some
minor differences. Ask your administrator for more information.
6 Open the “Network Properties” windows and agree to install “Windows
NT Networking”.
7 With “Wired to the Network” checked, click on “Next”.
8 Click on the option to “Select from list…” then on “Have Disk…”
9 Insert the driver disk and click on “OK”.
10 With “3Com EtherLink/Etherlink XL PCI Bus Master NIC” highlighted,
click on “OK”.
11 With the “3Com EtherLink/Etherlink XL PCI Bus Master NIC” listed in the
“Network Adapters:” window, click on “Next”.
12 Select all the applicable network protocols and click on “Next”.
Operating System Windows NT 4.0 Workstation
Driver Version 3.40.40
Driver File El90xnd4.sys
Server OS Novell NetWare 4.11 Server
Client OS
Client v4.6 for Windows NT