Hitachi Koki USA CMP4120HDUS - Manual (Page 17)

ENGLISH
8
INSTALLATION INSTRUCTIONS (continued)
Loading Batteries
1) Open the battery cover.
• Slide the battery cover towards the arrow mark while
pressing it.
2) Load batteries.
• Load two Size AA batteries included observing the
correct polarities.
3) Close the battery cover.
• Slide back the battery cover towards the arrow mark.
Handling the Remote Controller
• Use the remote controller within about 5 m from front of the
unit’s remote-control sensor and within 30 degrees on both
sides.
SELECT
With in 30
degrees
With in 30
degrees
About 5m
Handling the Remote Controller
•
Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
•
When loading batteries, observe their correct polarities as marked on
the product. If loaded in the wrong direction, the batteries could
explode or leak, resulting in fires, physical injury, or stains.
TIPS
•
Do not drop or impact the remote controller.
•
Do not splash the remote controller with water or put it on a wet
object to avoid possible failures.
•
Before leaving the remote controller out of use for an extended
period of time, remove the batteries from it.
•
If the remote controller begins to lack responsiveness, replace the
batteries.
•
Strong light such as direct sunlight impinging on the photoreceptor
of the remote control can cause operational failure. Position this unit
to avoid direct contact with such light.
CAUTIONS