Hasselblad 848 - Manual (Page 8)

Mounting and Unmounting
the Batch Feeder
The procedures for both mounting and unmounting the Feeder to/from
your scanner require that you use the software-guided procedure, which
ensures that the mechanical pars of the scanner and Feeder are correctly
aligned for each step. Always use this software feature when you need to
mount or unmount the Feeder. Otherwise, you may damage your Feeder
and/or scanner. Also, the unmount procedure makes sure that the Feeder
is correctly positioned for storage in its original box.
Mounting the Batch Feeder
Always use the software-guided procedure below to mount the Feeder. It
is otherwise possible to damage the Feeder and/or scanner while mount-
ing the Feeder
If you have not already done so, set up your Flextight Scanner, con-
nect it to your computer and install the FlexColor software as de-
scribed in your scanner and software user manuals. Confirm that the
scanner is working correctly by making a test scan using one of the
standard original holders.
If there is still an original holder mounted inside the scanner, then
remove it. Close the light table, if it is open, by lifting its front edge.
See your scanner manual for instructions.
Make sure the scanner is turned on and launch the FlexColor soft-
ware. If FlexColor is already running, then quit and restart the pro-
gram.
Select
Maintenance > Feeder from the FlexColor menu bar.
1.
2.
3.
4.