Hasselblad 848 - Manual (Page 31)

1
Preparing the Feeder for
Storage or Shipping
Storing the Feeder
To store the Feeder while it is not in use:
Detach the Feeder using the software-guided procedure given “Un-
mounting the Batch Feeder” on page 12.
Retrieve the box in which your Feeder was originally delivered. This
box is made of sturdy cardboard and includes a foam lining custom
cut to hold the Feeder safely and securely.
Lay the box down on the floor or on a table.
Open the box, remove the top slab of foam and set it aside.
Align the Feeder so that it will fit into the cut foam.
Lower the Feeder into the box.
Replace the top slab and close the box.
The Feeder is now prepared for storage
Shipping the Feeder
If you need to ship the feeder, for example to a new studio or back to Has-
selblad for service, then do the following:
Detach the Feeder using the software-guided procedure given “Un-
mounting the Batch Feeder” on page 12.
Retrieve both the original shipping screws and storage/shipping box
in which your Feeder was originally delivered.
1.
2.
3.
4.
5.
6.
7.
1.
2.