To reset the notebook, To change the boot device – HP Notebook PC User Manual
Page 26
Basic Operation
Operating Your Notebook
To reset the notebook
Occasionally, you may find that Windows or the notebook has stopped responding
and will not let you turn the notebook off. If this happens, try the following in this
order:
If possible, shut down Windows: press
ctrl+alt+del,
and then select
Shut Down > Restart.
–or, if this fails–
Press and hold the power button for at least 4 seconds until the display shuts
down. Any unsaved data will be lost. Then press the power button again
to restart.
–or, if this fails–
Insert the tip of a paper clip into the reset button on the bottom of the
notebook, and then press the power button to restart.
To change the boot device
The notebook normally boots from its internal hard disk. You can also boot the
notebook from a floppy disk drive, a CD-ROM drive, or an internal network
interface card.
1. Click Start > Turn Off Computer > Restart.
2. When the logo screen appears, press
esc
to display the Boot menu.
3.
Use the arrow keys to select the boot device, and press
enter.
If you want to boot from a specific device whenever it is present, change the
boot order using the BIOS Setup utility. See “Configuring Your Notebook”
in the “Troubleshooting and Maintenance” chapter in this guide.
18 Startup
Guide