High End Systems AF1000 User Manual
Page 18
1-6
Mini Controller User’s Manual
Connect the other end of the cable to an unused audio mixer output. Refer to
Figure 1.5.
Figure 1.5. Connecting the Audio Cable
Caution: Never connect a speaker level signal (cable from an amplifier output) to
the Audio input on the Mini Controller. Component damage will occur
and this action will void your Warranty! The line level should be from
100 mV to a maximum of 1 V peak to peak.
Note: a built in summing circuit combines the left and right signals together.
Apply power to the Mini Controller and AF1000 strobes. Installation and setup is
now complete. If you are experiencing any problems, refer to Appendix A for
possible solutions. If you can not resolve the problem yourself, contact High End
Systems Technical Support.