beautypg.com

Troubleshooting, 100 series, Doesn’t power up – Humminbird 161 User Manual

Page 91: Defaults to simulator with a transducer attached

background image

84

Troubleshooting

Before contacting the Humminbird® Customer Resource Center, please read the following
section. Taking the time to review these troubleshooting guidelines may allow you to solve
a performance problem yourself, and therefore avoid sending your unit back for repair.

100 Series

TM

Doesn’t Power Up

If your 100 Series

TM

Fishing System doesn’t power up, use the Installation Guide that also

comes with it for specific confirmation details, making sure that:

• The power cable is properly connected to the 100 Series

TM

Fishing System control

head.

• The power cable is wired correctly, with red to positive battery terminal and

black to negative terminal or ground.

• The fuse is operational.

• The battery voltage of the power connector is at least 10 Volts.

Correct any known problems, including removing corrosion from the battery terminals
or wiring, or actually replacing the battery if necessary.

100 Series

TM

Defaults to Simulator with a Transducer Attached

A connected and functioning transducer will cause the newly-started 100 Series

TM

Fishing System to go into Normal operating mode automatically. If, when you power up
the 100 Series

TM

Fishing System, it goes into Simulator mode automatically, even though

a transducer is already connected, this means that the control head is not detecting the
transducer. Perform the following troubleshooting tasks:

• Using the Installation Guide that also comes with your 100 Series

TM

Fishing

System, check to make sure that the transducer cable is securely connected
to the 100 Series

TM

Fishing System. Reconnect if necessary, and power up the

100 Series

TM

Fishing System again to see if this fixes the problem.

• Replace the non-functioning transducer with a known good transducer if

available and power up the control head again.

• Check the transducer cable. Replace the transducer if the cable is damaged or

corroded.