Connecting the printer to the network, Connecting the printer, To the network – HP Photosmart 8400 Series User Manual
Page 77: Configuration you have, then see
Ethernet network with Internet access by dial-up modem
The computers and printer communicate with each other, forming a simple network, through a
hub. One of the computers has access to the Internet through a modem and dial-up account.
None of the other networked devices, including the printer, have direct access to the Internet.
Some printer features, such as sharing photos directly from the printer over the Internet using
HP Instant Share, do not work in this configuration.
Ethernet network with broadband Internet access provided by a router
The printer is connected to a router that acts as a gateway between the user network and the
Internet. The full feature set of the printer, including sharing photos over the Internet, is available
without even having a computer available or connected to the network. This is the ideal network
configuration.
Connecting the printer to the network
To connect the printer to a wired network, you need the following:
●
A network access point such as a hub, router, or switch with an open port
●
A CAT-5 ethernet cable with RJ-45 plug
●
Broadband Internet access (only if you want to access HP Instant Share directly from the
device. For more information, see
).
Note 1
You should not connect the printer directly to a computer using an ethernet
cable. Peer-to-peer networking is not supported.
Note 2
After you connect the printer to the network as described in this section, you
must install the printer software. See
Installing the printer software on a Windows
or
Installing the printer software on a Macintosh
To connect the printer to the network
1.
Connect the ethernet cable to the back of the printer.
2.
Connect the ethernet cable to an empty port on the hub, router, or switch.
HP Photosmart 8400 series User's Guide
73