Henny Penny OEA - Manual (Page 9)

Model OFE/OFG/OEA/OGA-341, 342
Special Programming is used to set the items below:
ƒ Fahrenheit or Celsius
ƒ Initialize System
ƒ Lock or Unlock Controls
ƒ Fryer Type – Open or Pressure
ƒ Heat Source – Electric; Gas w/standing pilot;
Gas w/electronic ignition; Gas-Induced Draft
ƒ Vat Type - Split or Full Vat (frypot)
ƒ Oil Type - Solid or Liquid
1. To enter Special Programming, turn off power switch
(either side). Press and hold and turn the power
switch back on.
2. “SPEC” “PROG” followed by, “DEG” “°F” or “°C”. Use
to choose “°F” or “°C”.
3. Press and “INIT” shows in the display.
Press and hold the right and display shows “In-3”,
“In-2”, “In-1” followed by “Init Sys” “DONE DONE”. The
controls now are reset to factory parameters, the time set to
0:00 and temperature 190°F or 88°C.
4. Press and “LOCK” or “UNLOCK” shows in the
displays. Use to choose “LOCK” or
“UNLOCK”.
5. Press and “FRYR” shows in left display and the right
display should show “OPEN”. Use to change
from “PRES” to “OPEN” if needed.
6. Press and “FRYR” shows in the display. Use
to change the fryer type: “ELEC” for electric
models; “GAS” for units with standing pilot; SSI for units
with solid state ignition; IDG for units with induced draft gas
burners.
7. Press and “VAT” shows in the display. Use
to choose “SPLIT” or FULL” vat (frypot) type.
8. Press and “MELT” and “Solid” or “LIQD” shows in
the displays. Use to choose “Solid”, if using
solid shortening, or “LIQD”, if using liquid shortening.
9. Press and hold to exit Special Programming at any
time.
1209 3-9
3-6. C1000 SPECIAL
PROGRAMMING