HTC LZC5227 / 965879701 - Manual (Page 54)

LUBRICATION
54 - Husqvarna
Throttle and Choke Cables, Lever Bearings
Lubricate the cable ends by the carburetor with the oil
can. Move the controls to the end points and lubricate
again.
The throttle cable is also lubricated by the control
when the control console is removed.
On Kohler engine the cables are placed under the air
filter housing.
Front Wheel Mount
Lubricate with a grease gun, one zerk for each wheel
mount, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Bearings
Lubricate with a grease gun, one zerk for each set of
wheel bearings, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
8011-573-
Lubricating the front wheels
8011-574
Lubricating the cutting height adjuster
Mower Deck Height Adjuster
Lubricate using a grease gun, one zerk on right side,
until the grease squeezes out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.