HTC LZC5227 / 965879701 - Manual (Page 24)

CONTROLS
24 - Husqvarna
Mower Deck Lifting Lever
The lifting lever is used to place the mower deck in
the transport position or one of the 17 different cutting
height positions.
The cutting height is set by placing a peg in the hole
for the desired cutting height and the peg is then
locked on the inside (hidden in illustration) with the
supplied pin.
Pull the lever backward to the locked position •
to engage the transport position. The deck is
then fully raised.
To lower, squeeze the lock handle up to the
•
lifting lever while moving the lever forward.
When the lever meets the set peg, the desired
height is set.
The lifting lever can also be used to temporarily
•
adjust the cutting height, such as when passing
over a minor bump in the lawn.
8011-753
1. Lifting lever
2. Lock handle
3. Set peg
Mower deck lifting lever
Choke control
The choke control is used for cold starts to provide the
engine with a richer fuel mixture.
For cold starts, pull the control out to its extent.
8011-508
Choke control
Throttle control
The throttle control regulates the engine speed and
thereby the rate of rotation of the blades, assuming the
blade switch is pulled out (see Engaging the Mower
Deck).
To increase or decrease the engine speed, the control
is moved forward or back respectively.
Avoid idling the engine for long periods, as there is a
risk of fouling the spark plugs.
For best mower performance and battery charging,
USE FULL THROTTLE WHEN MOWING.
8011-509
Throttle control
1
2
3