HTC LZC5227 / 965879701 - Manual (Page 46)

MAINTENANCE
46 - Husqvarna
Cutter Blades
To attain the best mowing effect, it is important that the
blades are well sharpened and not damaged.
Bent or cracked blades or blades with large nicks
should be replaced.
Damaged blades should be replaced when hitting
obstacles that result in a breakdown. Let the service
workshop decide whether the blade can be repaired/
ground or must be replaced.
Balance the blades after sharpening.
Check the blade mounts.
IMPORTANT INFORMATION
The sharpening of blades should be carried
out by an authorized service workshop.
8011-604-02
Check the blades
8058-013-1
1. Blade
2. Cutter housing
3. Washer
4. Blade bolt, special
Blade attachment
1
2
3
4
Blade Replacement
Remove blade bolt by turning counterclockwise. •
Install new or re-sharpened blade with stamped •
“GRASS SIDE” facing towards ground/grass
(down) or “THIS SIDE UP” facing deck and cutter
housing.
Install and tighten blade bolt securely.
•
Torque blade bolt to 90 ft/lbs (122 Nm). •
IMPORTANT INFORMATION
Special blade bolt is heat treated.
Replace with a Husqvarna bolt if required.
Do not use a lower grade hardware than
specified.
WARNING!
Blades are sharp. Protect your hands
with gloves and/or wrap blades with
a heavy cloth when handling.