HTC LZC5227 / 965879701 - Manual (Page 52)

LUBRICATION
52 - Husqvarna
Checking Oil Level
8011-471
Oil dipstick
8009-159
Level marking
The importance of checking and maintaining
the proper oil level in the crankcase cannot be
overemphasized.
Check oil before each use as follows:
Make sure the engine is stopped, level, and 1.
cool so the oil has had time to drain into the oil
pan.
To keep dirt, debris, etc., out of the engine,
2.
clean the area around the dipstick before
removing it.
Unthread and remove the dipstick; wipe oil off.
3.
Reinsert the dipstick into the tube and rest the
cap on the tube. Do not thread the cap onto
the tube.
Pull the dipstick out and check the oil level.
4.
The oil level should be up to, but not over, the
“FULL” mark on the dipstick.
If the level is low, add oil of the proper type, up
5.
to the “FULL” mark on the dipstick. Refer to Oil
Type. Always check the level with the dipstick
before adding more oil.