HTC LZC5227 / 965879701 - Manual (Page 42)

MAINTENANCE
42 - Husqvarna
IMPORTANT INFORMATION
The end cover must be installed with the
rubber valve pointing downwards or the
rubber valve will not function.
Pull the main filter (outer) filter out. 1.
Remove the inner filter. 2.
Clean inside the filter housing, cover housing 3.
and dust cap. Wipe dry only.
Reinstall or replace the inner filter with the
4.
open end first, ensuring that it enters the
housing recess. Push in to the end.
Reinstall or replace the outer filter with the
5.
open end first so that it enters the recess. Push
in to the end.
Replace the end cover with the rubber valve
6.
pointing downwards and secure retaining clips.
8011-449
Removing the main filter
8011-450
Removing the inner filter
Engine Oil Cooler
Clean the outside of fins with a brush. 1.
Remove the two screws holding the cooler unit 2.
to the blower housing.
Tilt the cooler downward.
3.
Clean the inside of the cooler with a brush or 4.
with compressed air.
Reinstall the oil cooler to the blower housing.
5.
8011-472
Engine oil cooler