Honeywell HCE 60 User Manual
Page 40
Assigning zones and issuing room names
38
►
Press Installation button .
The LED of zone 1 flashes green.
►
Assign room names for heating.
►
Press Installation button .
The LED of zone 1 flashes green/orange.
►
Assign room names for cooling.
►
Repeat these steps until 2 room names are assigned to all tem-
perature zones.
Canceling assignment
Canceling assignment of setpoint adjuster to a temperature zone
►
Press and hold Installation button at least 2 seconds.
The LED illuminates. The LED of zone 1 flashes red.
►
Press Installation button repeatedly until the LED of the zone to be
removed flashes red.
►
Press Fault button
until the LED of the temperature zone goes
out.
The assignment of the setpoint adjuster to the temperature zone
has been canceled.