Honeywell HCE 60 User Manual
Page 38
Assigning zones and issuing room names
36
The LED on the storey controller in zone 1 illuminates green. The
name "Living" has been assigned to temperature zone 1.
►
Enter room name in zoning plan.
►
Repeat these steps until a room name is assigned to all temperature
zones.
►
Press the installation button until the LED extinguishes.
The storey controller is back in normal mode.
If the installation button is not pressed for longer than 4 min-
utes, the storey controller changes to normal mode.
The assigned temperature zones remain stored in the storey
controller, even after a power failure.
Assigning wireless setpoint adjuster HCU 30 to a
temperature zone
For information on assigning the wireless setpoint adjuster HCU 30 to
a temperature zone, refer to the operating instructions of the wireless
setpoint adjuster.