HP 100VG-ANYLAN B5426-90001 - Manual (Page 28)

28 Chapter 2
Service Information
Removal/Replacement Instructions
Removal/Replacement of the Adapter
For adapter removal, follow the procedures below:
1. Before removing the card, ensure that the operating system is shut
down and power to the host computer is switched off. Consult your
computer documentation for proper shutdown procedures to avoid file
corruption or loss of data.
2. Disconnect all cabling from the adapter.
3. Consult your computer documentation for instructions on the best
method for accessing the adapter slots.
4. Unscrew the two retaining screws and pull extractor levers out.
5. While holding extractor levers, slide the adapter out of its slot.
6. Place adapter in an antistatic bag.
7. Install a slot cover for proper cooling and RFI suppression.
To install a replacement adapter, follow the procedures described in the
installation section.