Harbor Freight Tools CENTRAL PNEAMATIC 95386 - Manual (Page 5)

Page 5 For technical questions, please call 1-800-444-3353. SKU 95386
compressor for operations different
from those intended could result in a
hazardous situation.
Service 5.
Have your compressor serviced a.
by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
compressor is maintained.
air compressor Safety Warnings
Risk of fire or explosion - do not 1.
spray flammable liquid in a confined
area or towards a hot surface. Spray
area must be well-ventilated. Do not
smoke while spraying or spray where
spark or flame is present. Arcing
parts - keep compressor at least 20
feet away from explosive vapors,
such as when spraying with a spray
gun.
Risk of bursting - Do not adjust
2.
regulator higher than marked
maximum pressure of attachment.
Risk of injury - Do not direct air
3.
stream at people or animals.
To reduce the risk of electric shock,
4.
do not expose to rain. Store indoors.
Wear ANSI-approved safety goggles
5.
during use.
Do not use to supply breathing air.
6.
Drain Tank daily and after use. 7.
Internal rust causes tank failure and
explosion.
Add correct amount of compressor
8.
oil before first use and every use.
Operating with low or no oil causes
permanent damage and voids
warranty.
Do not remove the valve cover or 9.
adjust internal components.
Compressor head gets hot during
10.
operation. Do not touch it or allow
children nearby during or immediately
following operation.
Do not use the air hose to move the
11.
compressor.
Release the pressure in the storage
12.
tank before moving.
The use of accessories or
13.
attachments not recommended by
the manufacturer may result in a risk
of injury to persons.
All air line components, including
14.
hoses, pipe, connectors, filters, etc.,
must be rated for a minimum working
pressure of 150 PSI, or 150% of
the maximum system pressure,
whichever is greater.
USE OF AN EXTENSION CORD
15.
IS NOT RECOMMENDED. If you
choose to use an extension cord, use
the following guidelines:
recommended mInImum WIre
GauGe For eXtenSIon cordS
(120 Volt)
namePlate
amPereS
(at full load)
eXtenSIon cord
lenGtH
25’ 50’ 100’ 150’
0 – 6 18 16 16 14
6.1 – 10 18 16 14 12
10.1 – 12 16 16 14 12
12.1 – 16 14 12 do not use.
table a
Make sure your extension cord is in a.
good condition.
Be sure to use an extension cord
b.
which is heavy enough to carry the