Harbor Freight Tools CENTRAL PNEAMATIC 95386 - Manual (Page 11)

Page 11 For technical questions, please call 1-800-444-3353. SKU 95386
the Pump Crankcase to reach the
“full” level in the Oil Sight Glass.
Replace the Oil Plug.
c.
If uncertain which oil to use for this 3.
compressor, please call Harbor
Freight Tools customer service at
1-800-444-3353 for assistance.
change the compressor oil after
4.
the first hour of use to remove any
debris.
WarnInG! To prevent serious injury from
burns: Do not add or change the oil
while the compressor is in operation.
Allow the compressor to cool before
replacing oil.
Initial run of the air compressor
Break in the new Air Compressor as 5.
follows:
Check the oil level (See Checking a.
the Oil).
Make sure the Power Button is OFF
b.
and the unit is unplugged. Insert a
male coupler (sold separately) into
the female Quick Coupler and fully
open all regulators and valves.
Plug in the Power Cord.
c.
Turn the Power Switch ON. d.
Let the unit run for 30 minutes. Air e.
will expel freely through the Coupler.
Turn the Power Button OFF.
f.
Unplug the Power Cord and remove g.
the male coupler.