Henny Penny ISLAND WARMER HMI-105 - Manual (Page 11)

Model HMI-103/105
2-6. AIR HEATERS 1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove pans and pan supports from unit.
3. Remove heater screws from inside of well.
4. Pull heater terminals out into interior of unit to access wires.
5. Remove wires from heater and pull heater from unit.
6. Install new heater.
2-7. POWER SWITCH 1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Open control panel cover and remove the four screws
securing the control panel.
3. Pull control panel out to access back of switch. Pull and
label the wires of switch.
203 2-3
Step 3
Step 5
Step 2
Step 3