Henny Penny ISLAND WARMER HMI-105 User Manual
Page 10
Model
HMI-103/105
2-4. RADIANT HEATERS
1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove screws from access panel on both sides of radiant
heater and let light socket and heater hang down.
3. Remove screw from inner side of access panel.
4. Remove wires from heater; pull radiant heater from panel.
5. Install new radiant heaters.
The radiant heaters are paired and wired in series. If one
heater is bad, two won’t heat.
2-5. LIGHT SOCKET
1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove screws from access panel on both sides of light
socket,
as shown above in the Radiant Heaters Section.
3. Remove wires from light socket.
4. Depress retainer on light socket and push through panel.
5. Install new light socket.
2-2
203
Step 2
Step 3
Step 4
Step 3
Step 4