Figure 2-20, Ptz window – Honeywell HREP4 User Manual
Page 38
38
Installation
Use the
to change the values, then click OK to save the settings.
Note
Some settings such as AUTO FOCUS might not be compatible with your
particular PTZ equipment. If this is the case, then changing the value will not
have an effect on the PTZ control.
Configuring PTZ Presets in Live View
Configure PTZ presets for a preset tour. See
1. Navigate to PTZ
in the Control bar, then click
to select. The PTZ window
appears.
Figure 2-20
PTZ Window
2. Select the camera by channel.
3. Select a preset number.
4. Use the arrow buttons to reposition the PTZ camera field of view.
5. Use ZOOM, FOCUS, and IRIS to change the current camera view.
6. Click PARAMETER to configure PTZ camera parameters.
7. Click SET to save the settings.
See
on
for descriptions of front panel and remote controller controls for
PTZ cameras.
Configuring PTZ Camera Parameters
Click PARAMETER in the PTZ camera window, and the PTZ Parameter window appears.
Select the camera channel