Hoover S3239 - Manual (Page 21)

4. Line up locator on end sections
with slot on agitator. Push end
sections into position.
Note: The pulley end section has
a U-shaped locator that fits into
the U-shaped slot on the appro-
priate agitator
5. Slide new brush roll onto
pulley end section, fitting in-
dented areas on brush roll over
projections on end section. Ar-
row in brush roll must point to-
ward agitator.
6. Screw on end plates and
tighten.
7. Should you accidentally dis-
place any part of the agitator dur-
ing assembly, reassemble as
shown.
Replace belt, agitator and nozzle cover.
The headlight
The headlight located on top of the electronic power nozzle operates
when the cleaner is turned on.
Note: The headlight bulb is part of the electronic circuit and the elec-
tronic power nozzle motor will not operate if the bulb is burned out.
The bulb must be replaced with a 15 watt bulb. Use Hoover part
number 16113 or Sylvania bulb.
How to replace the headlight
Disconnect cleaner from electrical outlet and disconnect electronic
power nozzle from extension wands.
19